Filter
Top Products
Form Number TM61310 Rev 2 Aug 2007
Page 9
Replacing Fuses
Warning
To avoid electrical shock, remove the test leads and any input signals before replacing
battery or fuses.
the
amage or injury, INSTALL ONLY quick acting fuses with the following Amp/Volt
F-310 Fuse: 250mA 250V FAST BLOW
Fu
3. Remove the two screws under the battery cover.
case until the case unsnaps from the front case near display.
rn the back case cover, reinsert the case screws.
replace the old battery with a new battery.
To prevent d
current interrupt rating:
Fuse
se Replacement
The 61-310 replacement fuse is part number: F-310
Fuse Rating is: 250mA 250V FAST BLOW
1. Remove the rubber holster.
2. Remove the two screws on the battery cover and open the battery cover.
4. Lift up on the back
• Replace the defective fuse with the standard rated fuse for this meter.
5. Retu
• It is recommended to
6. Return the battery cover and reinstall the two battery cover screws.
7. Replace the rubber boot.
Caution Use only a fuse with the amperage, interrupt voltage, and speed rating
specified.
Cleaning
Warning
To avoid electrical shock or damage to the meter, never allow water inside the case. To avoid
damaging the meter’s housing, never apply solvents to the meter.