JVC GR-D796U Camcorder User Manual


 
MasterPage: Heading0_Left
24 EN
D.S.C. RECORDING
You can use your camcorder as a Digital Still
Camera for taking snapshots. Still images are
stored in the memory card.
NOTE:
Before continuing, perform the procedures listed
below:
Power ( pg. 13)
Loading a Memory Card ( pg. 17)
Remove the lens cap.
Open the LCD monitor fully. ( pg. 8)
1 Set the VIDEO/MEMORY Switch to
MEMORY.
2 Set the Power Switch to REC while
pressing down the Lock Button located on the
switch.
To change the Picture Quality, pg. 29, 31.
3 Press SNAPSHOT. The
PHOTO
indication
appears while the snapshot is being taken.
To delete unwanted still images, refer to
Deleting Files ( pg. 27).
When you do not want to hear the shutter
sound, set MELODY to OFF( pg. 32).
NOTE:
If shooting is not performed for approx. 5 minutes
when the Power Switch is set to REC and power
is supplied from the battery pack, the camcorder
shuts off automatically to save power. To perform
shooting again, push back and pull out the
viewnder again or close and re-open the LCD
monitor.
Appears when you attempt to shoot digital still
images when the write protection tab on the SD
Memory Card is set to the LOCK position.
Appears if there is no memory card loaded when
the SNAPSHOT Button is pressed.
Approximate Number of Storable Images
The number increases or decreases depending
on the Picture Quality/Image Size, etc.
Basic Shooting (D.S.C. Snapshot)
CHECK CARDS WRITE PROTECTION
SWITCH
MEMORY CARD!
MEMORY
VIDEO
Power Switch
Lock Button
VIDEO/
MEMORY
SNAPSHOT
Image Size/Picture
Quality
SD Memory Card
8 MB 16 MB 32 MB 64 MB
640 x 480/FINE
640 x 360/FINE
47 95 205 425
640 x 480/STANDARD
640 x 360/STANDARD
160 295 625 1285
Image Size/Picture
Quality
MultiMediaCard
8 MB 16 MB 32 MB
640 x 480/FINE
640 x 360/FINE
55 105 215
640 x 480/STANDARD
640 x 360/STANDARD
190 320 645
DIGITAL STILL CAMERA (D.S.C.) RECORDING &
PLAYBACK
GR-D796US_EN.book Page 24 Friday, December 15, 2006 11:31 AM