Filter
Top Products
28
RECORDING
Advanced Features (cont.)
Self-Timer
You can set the delay between pressing RECORDING
START/STOP and the actual start of recording. If you
secure the camcorder, you (or whomever is operating the
camcorder) can enter the scene before recording starts.
NOTE:
Make sure the camcorder is in the Record-Standby mode
before performing the following steps.
ACCESS MENU SCREEN
1
Turn the PROGRAM AE select dial to any position
except AUTO LOCK, then press MENU.
SET INTERVAL TIME
2
Press – or + to move the highlight bar down to
“INTERVAL TIMER”, then press FAR or NEAR to
cycle through the choices. Stop when the desired
time appears. Choose from “15S”, “30S”, “1MIN”,
“5MIN”, or select to turn the function “OFF”.
CLOSE MENU
3
Press MENU.
START DELAYED RECORDING
4
Press RECORDING START/STOP. The tally lamp
begins blinking, and the blinking frequency
increases about 5 seconds before recording is to
start. Once recording begins, the lamp stops
blinking but stays lit.
To Release Self-Timer . . .
..... while the tally lamp is blinking, press RECORDING
START/STOP to stop the blinking, then set
“INTERVAL TIMER” to “OFF”.
1MIN
1/2S
GAIN UP S.LX
TELE MACRO OFF
INTERVAL TIMER OFF
REC TIME OFF
JLIP ID NO. 07
SET CHARACTER
DATE/TIME
END :MENU KEY
OFF
15S30S
1MIN5MIN
OFF
1/4S
1/2S1S
+
–
NEAR
Interval
Timer Indicator
Rec Time Indicator
Tally lamp
MENU
FAR