Filter
Top Products
VIDEO RECORDING & PLAYBACK
EN 11
MasterPage: Video_Heading0_Right
VIDEO RECORDING
NOTE:
Before continuing, perform the procedures listed below:
● Power (੬ pg. 6)
● Loading A Cassette (੬ pg. 10)
1 Remove the lens cap.
2 Open the LCD monitor fully. (੬ pg. 12)
3 Set the VIDEO/MEMORY Switch to “VIDEO”.
(GR-D93/73 only)
4 Set the Power Switch to “A” or “M” while pressing
down the Lock Button located on the switch.
● The POWER/CHARGE lamp lights and the camcorder
enters the Record-Standby mode. “PAUSE” is displayed.
● To record in LP (Long Play) mode, ੬ pg. 25, 26.
5 To start recording, press the Recording Start/Stop
Button. The “T REC” appears on the display while
recording is in progress.
6 To stop recording, press the Recording Start/Stop
Button again. The camcorder re-enters the Record-
Standby mode.
NOTES:
● The image will not appear simultaneously on the LCD
monitor and the viewfinder.
● If the Record-Standby mode continues for 5 minutes, the
camcorder’s power shuts off automatically. To turn the
camcorder on again, push back and pull out the viewfinder
again or close and re-open the LCD monitor.
● LCD monitor/viewfinder indications:
• When power is supplied from a battery: the “”
battery indicator is displayed. (੬ pg. 43)
• When power is supplied from an AC outlet: the “”
battery indicator does not appear.
● When a blank portion is left between recorded scenes on
the tape, the time code is interrupted and errors may occur
when editing the tape. To avoid this, refer to “Recording
From The Middle Of A Tape” (੬ pg. 13).
● To turn the beep sounds off, ੬ pg. 25, 27.
● For other notes, ੬ pg. 38.
Basic Recording
POWER/CHARGE lamp
Recording Start/Stop Button
Power Switch
Lock Button
Power Zoom Lever
Push.
VIDEO RECORDING & PLAYBACK
GR-D73US.book Page 11 Thursday, November 20, 2003 10:50 AM