Filter
Top Products
TROUBLESHOOTING
42 EN
MasterPage: Left
● In places subject to low temperature, images become dark
due to the characteristics of the LCD monitor. When this
happens, the displayed colors differ from those that are
actually recorded. This is not a defect of the camcorder.
HAdjust the brightness and angle of the LCD monitor.
(੬ pg. 9, 12)
● When the LCD monitor’s fluorescent light reaches the end
of its service life, images on the LCD monitor become dark.
HConsult your nearest JVC dealer.
● The LCD monitor and the viewfinder are made with high-
precision technology. However, black spots or bright spots
of light (red, green or blue) may appear constantly on the
LCD monitor or the viewfinder during recording or
playback. These spots are not recorded on the tape. This is
not due to any defect of the unit. (Effective dots: more than
99.99 %)
● This may occur when the surface or the edge of the LCD
monitor is pressed.
● The battery’s charge is low.
HInstall a fully charged battery. (੬ pg. 6, 7)
— (GR-D93/73 only) —
HPush in the memory card a few more times. (੬ pg. 10)
● The viewfinder is pulled out and “PRIORITY” is set to
“FINDER”.
HPush the viewfinder back in or set “PRIORITY” to “LCD”.
(੬ pg. 12, 25, 27)
● The LCD monitor’s brightness setting is too dark.
HAdjust the brightness of the LCD monitor. (੬ pg. 9)
HIf the monitor is tilted upward 180 degrees, open the
monitor fully. (੬ pg. 12)
● The speaker volume is too great.
HTurn the speaker volume down. (੬ pg. 14)
HWipe them gently with soft cloth. Wiping strongly can
cause damage. (੬ pg. 48) To clean the viewfinder, please
consult your nearest JVC dealer.
● “TIME CODE” is set to “OFF”.
HSet “TIME CODE” to “ON”. (੬ pg. 25, 27, 28)
● A malfunction of some kind has occured. In this case the
camcorder’s functions become unusable.
H੬ pg. 44.
● A malfunction of some kind has occured. In this case the
camcorder’s functions become unusable.
H੬ pg. 44.
— (GR-D93/73 only) —
● “REMOTE” is set to “OFF”.
HSet “REMOTE” to “ON”. (੬ pg. 25, 27)
● The remote control does not point at the remote sensor.
HPoint at the remote sensor. (੬ pg. 15)
● The remote control batteries are exhausted.
HReplace the batteries with fresh ones. (੬ pg. 15)
Images on the LCD monitor appear dark or whitish.
Colored bright spots appear all over the LCD
monitor or the viewfinder.
The indicators and the image color on the LCD
monitor are not clear.
The cassette will not load properly.
The memory card cannot be removed from the
camcorder.
Picture does not appear on the LCD monitor.
Images on the LCD monitor are jittery.
The LCD monitor, the viewfinder and the lens have
become dirty (ex. fingerprints).
Time code does not appear.
An error indication (E01, E02 or E06) appears.
An error indication (E03 or E04) appears.
The remote control does not work.
GR-D73US.book Page 42 Thursday, November 20, 2003 10:50 AM