Filter
Top Products
36
EN
ADVANCED FEATURES
(cont.)
MANUAL
AUTO
PLAY
OFF
ORMATF
EXECUTE
DATA?EXISTING
ERASE ALL
RETURN
MENU/BRIGHT Wheel
Lock Button
Power Switch
Display
Making A New Folder
New still pictures you are going to take can be
separated from previously shot pictures by resetting
the file name to DVC00001; these new pictures will
be stored in a new folder.
1 Set the VIDEO/MEMORY Switch to “MEMORY”,
then set the Power Switch to “PLAY” while pressing
down the Lock Button located on the switch.
• A stored file is displayed.
2 Make sure an IMAGE file is displayed
(੬ pg. 28); if not, press SELECT to access the
MEMORY SELECT Screen. Rotate the MENU/
BRIGHT wheel to select “IMAGE” and press it.
3 Press the MENU/BRIGHT wheel in. The Menu
Screen appears. Rotate the MENU/BRIGHT wheel to
select “NO. RESET”, then press it. The NO. RESET
Screen appears.
4 Rotate the MENU/BRIGHT wheel to select
“EXECUTE”, then press it. The new folder (such as
“101JVCGR”) will be made and the file name of the
next shot starts from DVC00001.
Initialising A Memory Card
You can initialise a memory card anytime.
After initialising, all files and data stored on the
memory card, including those which have been
protected, are cleared.
1 Perform step 1 of “Making A New Folder” above.
2 Press the MENU/BRIGHT wheel in. The Menu
Screen appears. Rotate the MENU/BRIGHT wheel to
select “FORMAT” and press it. The FORMAT Screen
appears.
3 Rotate the MENU/BRIGHT wheel to select
“EXECUTE” and press it. The memory card is
initialised. When initialisation is finished, “NO
IMAGES STORED” or “NO E-MAIL CLIP STORED”
appears.
• To cancel initialisation, rotate the MENU/BRIGHT
wheel to select “RETURN” and press it.
CAUTION
Do not perform any other operation (such as turning
off the camcorder) during initialisation. Also, be sure
to use the provided AC Adapter, as the memory card
may be corrupted if the battery becomes exhausted
during initialisation. If the memory card becomes
corrupted initialise it.
Menu Screen
VIDEO/MEMORY Switch (Open the
LCD monitor to access this switch.)
Folder and File names
Each time shooting takes place, a file name is
made using a number which is larger by one than
the largest number of the file names which are in
use. Even if you delete an image file with a
number in the middle of range, the number will
not be used for a new shot; a gap will remain in
the numerical sequence. If the file name reaches
DVC09999, a new folder (such as “101JVCGR”)
will be made and the file name will start again
from DVC00001.
SELECT Button