Filter
Top Products
11
RECORDING
Set REC MODE, S-VHS (S-VHS ET)**, TAPE
LENGTH and DATE/TIME in SYSTEM MENU.
(
੬ pg. 18 – 21, “MENU SETTINGS”)
1 Remove the lens cap. Set the Power Switch @
to “ ” or “ ”.
Shooting while using the viewfinder: Make sure
the LCD monitor* is closed and locked.
Shooting while using the LCD monitor*: Make
sure the LCD monitor* is fully open.
The camcorder enters the Record-Standby mode
and “PAUSE”
is displayed.
•If you tilt the LCD monitor* upward to 180
degrees, the viewfinder switches back on and the
monitored image can be viewed both on the LCD
monitor* and in the viewfinder, so the person you
shoot can view himself/herself.
2 Press the Recording Start/Stop Button !.
appears while recording is in progress.
•To stop recording, press the Recording Start/Stop
Button
!. The camcorder re-enters the Record-
Standby mode.
To Adjust The Brightness Of The LCD Monitor*,
rotate the BRIGHT Wheel
1 until the bright level
indiator
on the display moves and the
appropriate brightness is reached.
•If you are using the GR-AX970, it is also possible
to adjust the brightness of the viewfinder by
adjusting as described above.
* Applicable models only.
**GR-SXM740/SXM340/SXM240 only.
•Tapes recorded on S-VHS or S-VHS ET
(
੬ pg. 18, 20) cannot be played back correctly
on a normal VHS VCR.
To playback on a regular VHS VCR, use a VHS
tape and select S-VHS ET (OFF) in SYSTEM
MENU (
੬ pg. 18, 20).
PLAYBACK
1 Load a tape (੬ pg. 8, “Loading/Unloading A
Cassette”).
2 Set the Power Switch @ to “ ”. To start
playback, press
4
/6 ^ or T.
To stop playback temporarily (Still Playback), press
4
/6 ^ or s. To stop playback, press 5 $. Press
2
% to rewind, or
3
& to fast-forward the tape.
High-speed picture search (Shuttle Search) is
possible by pressing
2
% or
3
& during
playback (holding
2
% or
3
& down during
playback continues search until released). To
resume normal playback, press
4
/6 ^ or T.
For VIDEO RECORDING/VIDEO PLAYBACK
•The camcorder shuts off automatically after about
5 minutes in the Record-Standby or Stop mode.
To turn on again, set the Power Switch
@ to
“OFF”, then to “
”, “ ” or “ ”.
•When the Power Switch
@ is set to “ ”, “ ” or
“
” and the LCD monitor* is opened at an
angle of 60 degrees or more, the LCD monitor*
switches on and the viewfinder switches off
automatically to save power.
•The playback picture can be viewed in the
viewfinder (with the LCD monitor* shut), on the
LCD monitor* or on a connected TV (
੬ pg. 15,
“Connections To A TV/VCR”).
•To remove the indications,
੬ pg. 21, DISPLAY or
OSD OUTPUT in SYSTEM MENU.
•To control the speaker* volume, slide VOL.
3
towards “+” to turn up, or towards “–” to turn
down. While shooting, sound is not heard from
the speaker*.
•If TBC (
੬ pg. 14) is engaged during Still
Playback, noise bars will not appear
(GR-SXM740/SXM340 only).
* Applicable models only.
GR-SXM740U_EN 24/03/1905, 9:21 PM11