Filter
Top Products
ADDITIONAL FEATURES FOR D.S.C.
30 EN
MasterPage: Left
5 Press + or – to select
“EXECUTE”, and press
MENU. The normal
playback screen appears.
● To cancel selection, select
“RETURN”.
To Print By Selecting Still Images And
Number Of Prints
1 Perform steps 1 – 3 in “To Print All Still
Images (One Print For Each)”.
2 Press + or – to select
“CURRENT”, and press
MENU. The DPOF screen
appears.
3 Slide the Power Zoom
Lever towards “T” or “W” to
select the desired file.
4 Press + or – to select the number indication
(00), and press MENU.
5 Select the number of
prints by pressing + to
increase the number, or –
to decrease the number,
and press MENU.
● Repeat steps 3 through 5
for the desired number of
prints.
● The number of prints can be set up to 15.
● To correct the number of prints, select the image
again and change the number.
6 Press + or – to select
“RETURN”, and press
MENU. The “SAVE?”
appears.
● If you did not change any
settings in step 3 through
5, the Menu Screen
reappears.
7 Press + or – to select “EXECUTE” to save the
setting you have just made, and press MENU.
● To cancel selection, select “CANCEL”.
To Reset The Number Of Prints
1 Perform steps 1 – 3 in “To Print All Still
Images (One Print For Each)”.
2 Press + or – to select “RESET”, and press
MENU. The DPOF screen appears.
3 Press + or – to select “EXECUTE”, and press
MENU. The normal playback screen appears.
● To cancel selection, select “RETURN”.
● The number of prints is reset to 0 for all still
images.
CAUTION:
While performing the above, never disconnect
power, as this may cause the memory card to be
corrupted.
You can initialise a memory card any time.
After initialising, all files and data stored in the
memory card, including those which have been
protected, are cleared.
1 Set the VIDEO/MEMORY Switch to
“MEMORY”.
2 Set the Power Switch to “PLAY” while
pressing down the Lock Button located on the
switch.
3 Press MENU. The Menu Screen appears.
4 Press + or – to select
“FORMAT”, and press
MENU. The FORMAT
screen appears.
5 Press + or – to select
“EXECUTE”, and press
MENU. The memory card
is initialised.
● When initialisation is finished, “NO IMAGES
STORED” appears.
● To cancel initialisation, select “RETURN”.
CAUTION:
Do not perform any other operation (such as
turning off the camcorder) during initialisation.
Also, be sure to use the provided AC Adapter, as
the memory card may be corrupted if the battery
becomes exhausted during initialisation. If the
memory card becomes corrupted, initialise it.
DPOF
EXECUTE
ALL1?
RETURN
RETURN
SHEETS
DPOF
00
SHEETS
DPOF
05
DPOF
EXECUTE
SAVE?
CANCEL
Initialising A Memory Card
ORMATF
EXECUTE
DATA?EXISTING
ERASE ALL
RETURN
GR-D280PAL.book Page 30 Saturday, January 22, 2005 4:09 PM