Filter
Top Products
MasterPage: Video_Heading0_Right
EN
21
RECORDING & PLAYBACK
VIDEO PLAYBACK
1 Load a cassette. (੬ pg. 16)
2 Set the VIDEO/MEMORY Switch to
“VIDEO”.
3 Set the Power Switch to “PLAY” while
pressing down the Lock Button located on the
switch.
●
The above screen (referring to the control lever
(
੬ pg. 7)) will be displayed for approx. 3
seconds on the LCD Monitor.
4 To start playback, press 6.
5 To stop playback, press 7.
●
During Stop mode, press 1 to rewind, or ¡
to fast-forward the tape.
● Press SET to display the guide operation
screen.
To control the speaker volume
Slide the Power Zoom Lever (VOL. +/–)
towards “+” to turn up the volume, or towards
“–” to turn down the volume.
NOTES:
● The playback picture can be viewed in the LCD
monitor, viewfinder or on a connected TV.
(
੬ pg. 23)
● If Stop mode continues for 5 minutes when
power is supplied from a battery, the camcorder
shuts off automatically. To turn the camcorder on
again, push back and pull out the viewfinder
again or close and re-open the LCD monitor.
● When a cable is connected to the AV connector,
the sound is not heard from the speaker.
Appears when pictures recorded in the HDV
format are detected. The pictures in the HDV
format cannot be played back with this
camcorder.
Still Playback
Pauses during video playback.
1) Press 6 during playback.
2) To resume normal playback, press 6
again.
●
If still playback continues for more than about
3 minutes, the camcorder’s Stop mode is
automatically engaged.
Normal Playback
Operation To select
6
Move the control lever up.
7
Move the control lever down.
¡
Move the control lever right.
1
Move the control lever left.
Speaker
66
66
Lock Button
¡¡
¡¡
7
MENU
11
11
VOL. +/–
VIDEO/
MEMORY
Power
Switch
BLANK
SET
HDV
GR-D770UC_EN.book Page 21 Thursday, December 14, 2006 7:55 PM