Filter
Top Products
EN91
Indications Function
Displays the battery remaining power.
Remaining power level: high
Remaining power level: exhausted
As the battery power comes close to nil, the battery indicator blinks.
When the battery power is exhausted, power turns off automatically.
Appears when no tape is loaded. (੬ pg. 10)
Appears when the erase protection tab is set to “SAVE” while the POWER
Switch is set to “ ”. (੬ pg. 10)
Appears if dirt is detected on the heads during recording. Use an optional
cleaning cassette. (੬ pg. 94)
Appears if condensation occurs. When this indication is displayed, wait
more than 1 hour until condensation disappears.
Appears if a tape is not loaded when START/STOP is pressed while the
POWER Switch is set to “ ” and the MODE Dial is set to “VIDEO”,
“ ” or “
DUAL
”.
Appears when the tape ends during recording or playback. (੬ pg. 17)
Appears if a tape in another format is loaded.
●Appears when the date/time is not set. (੬ pg. 9)
●Appears when the built-in clock (lithium) battery is discharged and the
previously set date/time is erased. (੬ pg. 9)
Appears if Audio Dubbing is attempted on a blank portion of a tape.
(੬ pg. 76)
●Appears if Audio Dubbing is attempted on a tape recorded in the LP
mode. (੬ pg. 76)
●Appears if Audio Dubbing is attempted on a tape recorded in 16-bit
audio. (੬ pg. 76)
●Appears if A. DUB (e) on the remote control is pressed when the erase
protection tab is set to “SAVE”. (੬ pg. 76)
Appears when the MultiMediaCard’s memory is full and shooting is not
possible.
Warning Indications
TAPE!
TAPE END
SET DATE/TIME!
MEMORY IS FULL
CHECK TAPE’S ERASE
PROTECTION SWITCH
HEAD CLEANING
REQUIRED USE
CLEANING CASSETTE
CONDENSATION
OPERATION PAUSED
PLEASE WAIT
DIFFERENT
FORMATTED TAPE
A. DUB ERROR!
<CANNOT DUB
ON A LP RECORDED
TAPE>
<CANNOT DUB
ON A 16BIT
RECORDING>
<CHECK TAPE’S ERASE
PROTECTION SWITCH>
A. DUB ERROR!
CONTINUED ON NEXT PAGE