Filter
Top Products
14
Necessary Settings before Use
Charging the Battery Pack
1
Close the LCD monitor to turn off the
camera.
2
Attach the battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camera
BATT.
3
Connect the AC adapter.
•
You can also connect the AC adapter using
the Everio dock connector.* (੬ pg. 9)
* GZ-MG330 model does not include the
Everio dock.
•
The access/charge lamp blinks to indicate
charging has started.
•
When the lamp goes out, charging is
fi nished. Unplug the AC adapter from the
AC outlet and disconnect the AC adapter
from the camera
To detach the battery pack
Slide and hold BATT. (੬ step 2), then
remove the battery pack.
To check the remaining battery power
See page 15.
NOTES
•
You can also use the camera with just the
AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
Date/Time Setting
1
Open the LCD monitor to turn on the
camera.
2
When [SET DATE/TIME!] appears,
select [YES] within 10 seconds.
SET DATE/TIME!
YES
NO
If you do not select within 10 seconds, the
screen disappears. In such case, press
the POWER button and turn the camera
on again.
3
Set the date and time.
DATE TIME
JAN 31
11
AM
07
2007
Repeat this step to input the month, day,
year, hour and minute.
To change the date and time
1) Touch the MENU button.
2) Select [BASIC SETTINGS], and then
[CLOCK ADJUST].
3) Set the date and time.
To return to the previous screen
Select
.
To quit the screen
Touch the MENU button.
DC Jack
AC Adapter
To AC Outlet
(110V to 240V)