Filter
Top Products
19
Additional Cautions
z
Cautions for setting the detection function
You cannot set motion detection, audio detection, and tampering detection at the same time.
An error message is displayed when one detection function setting is already enabled and you try to select
another. Check the content of the error message, set the already-enabled detection function to "OFF", and
then reconfigure the detection function. () "Instructions (Setting)" ─ "Operations" ─ "Motion Detection Page",
"Audio Detection Page", "Tampering Detection Pages")
z
Cautions for changing the encoding setting
When changing an already-configured encoding setting on the Basic Settings 2 page, Encoding page, or SD
recording page, PTZ and the auto patrol settings are cancelled.
In this case, set PTZ and the auto patrol settings again after setting the encoding setting. ()"Instructions
(Setting)" ─ "Operations" ─ "PTZ Page", "Auto Patrol Page")
z
Checking the software version
Check on the following screen that the software version is "1.4.30".
Click [Advanced Settings] and [Miscellaneous]
Check that this is
"1.4.30".