Filter
Top Products
EN63
INDEX
Docking Station
1 PC Connector [DIGITAL STILL] ............ ੬ pg. 42
2 J Terminal/Edit Connector [JLIP (Joint Level
Interface Protocol) (EDIT)] .................... ੬ pg. 51
•Connect to a JLIP-compatible camcorder or
VCR to control it from the computer using the
provided Software.
NOTE:
Make sure that the camcorder is turned on while
connecting the camcorder to a PC using the
Docking Station’s JLIP connector. If the camcorder
is turned off (because the POWER Switch is set to
“OFF” or due to Auto Shut Off* etc.) while the
JLIP program software is used, it will be impossi-
ble to control the connected devices from the
computer. In such a case, first try turning the
camcorder on again, or unplug the JLIP connec-
tion cable from the Docking Station’s JLIP
connector. Then, initialize or run the software
again.
* Auto Shut Off:
If 5 minutes elapse in the Record-Standby mode
or in the Pause mode, the camcorder’s power
shuts off automatically to conserve energy.
•Connect the editing cable when performing
Random Assemble Editing ........ ੬ pg. 50 – 55.
4
5
6
1
3
0
2
7
8
9
3 External Stereo Microphone Input
Connector [MIC] ................................. ੬ pg. 56
4 Stud .................................................... ੬ pg. 40
5 Screw .................................................. ੬ pg. 40
6 Multi Connector
The Docking Station can be connected with this
camcorder through this connector. Never touch it
with your hand or hit it with a hard object; if the
pins are damaged, the connectors will become
unusable due to contact failure.
7 S-Video Output Connector
[S OUT] ........................................ ੬ pg. 40, 51
8 Video Output Connector
[VIDEO] ........................................ ੬ pg. 40, 51
9 Audio Output Connector
[AUDIO L/R] ................................. ੬ pg. 40, 51
0 Screw Knob ......................................... ੬ pg. 40
To attach the camcorder, tighten this clockwise.