Filter
Top Products
EN51
ZOOM (T/W)
PLAY
STOP
START/STOP
INT. TIME
REC TIME
1
1
M
/
I
2
N
S
Interval time
indicator
Recording time
indicator
Remote sensor
Remote sensor
Playback Zoom
To magnify the recorded image up to 10X at any time
during playback.
NOTES:
●
Use the remote control unit to perform this procedure.
●
Make sure that the TBC mode is activated (
੬
pg. 23).
1) Press PLAY to find the scene of interest.
2) Press the ZOOM Buttons (T/W) on the remote control.
Make sure the remote control is pointed at the
camcorder’s remote sensor. Pressing T zooms in.
To End Zoom . . .
.... press and hold W until magnification returns to
normal. Or, press STOP and then press PLAY.
NOTES:
●
Zoom can also be used during still playback.
●
Due to digital image processing, the quality of the image
may suffer.
●
After zooming in on a still video image, when normal
playback is started, the zoomed-in effect is momentarily
canceled but then resumes, returning magnification to
the previously set level.
Animation And Time-Lapse
The remote control lets you set/release Interval Time and
Recording Time without using the Menu Screen.
Animation
1) Set
Instead of performing steps 1 and 2 on pg. 48
(“Animation”), press REC TIME on the remote control.
Each time REC TIME is pressed, the Recording Time
indicator appears, changing in the following order:
1/4S, 1/2S, 1S, 5S and no indication (off).
2) Release
Instead of using the Menu in step 5 on pg. 48
(“Animation”), press REC TIME on the remote control
until the Recording Time indicator disappears.
Time-Lapse
1) Set
Instead of performing steps 1 and 2 on pg. 48 (“Time-
Lapse”), press REC TIME and INT. TIME on the remote
control. Each time REC TIME is pressed, the Recording
Time indicator appears, changing in the following
order: 1/4S, 1/2S, 1S, 5S and no indication (off). Each
time INT. TIME is pressed, the Interval Time indicator
appears, changing in the following order: 15S, 30S,
1MIN, 5MIN and no indication (off).
2) Release
Instead of using the Menu in step 4 on pg. 48 (“Time-
Lapse”), press REC TIME and INT. TIME on the remote
control until the indicators disappear.
NOTE:
Also refer to pg. 48.
Display