Filter
Top Products
EN33
01
04
03
06
02
05
<
DELETE
>
NEXT
S
A
E
E
L
X
L
L
I
E
T
CT
DELETE
C
E
A
N
N
T
C
E
E
R
L
DELETE
C
E
A
N
N
T
C
E
E
R
L
DELETE
Deleting Images
Previously shot images can be deleted either one at a time or
all at once.
1
Set the Power Switch to “ ”. If the DSC Lamp is not
lit, press REFRESH for approx. 1 second to select “DSC”.
2
Press the MENU Wheel in. The Menu Screen appears.
3
Rotate the MENU Wheel to select “DELETE” and press it.
The DELETE Menu appears.
TO SELECT AN IMAGE BY BROWSING
IMAGES STORED IN MEMORY
Before doing the following, perform steps 1 through 3 above.
4
Rotate the MENU Wheel to select “SELECT” and press it.
The Delete Select Menu appears.
5
Rotate the MENU Wheel to move the frame to the desired
image that you wish to delete and press it. An “
”
appears above the selected image.
Repeat this procedure for all images that you wish to
delete.
6
Rotate the MENU Wheel upward to select “NEXT” and
press it. The Delete Execute Menu appears.
7
Rotate the MENU Wheel to select “ENTER” and press it.
After “ENTER” blinks, the selected images are deleted
and the Menu Screen reappears. Press the MENU Wheel
in again to close the Menu Screen.
•To cancel deletion, rotate the MENU Wheel to select
“CANCEL” and press it twice. The Menu Screen closes.
TO DELETE ALL IMAGES
Before doing the following, perform steps 1 through 3 above.
4
Rotate the MENU Wheel to select “ALL” and press it. The
Delete Excute Menu appears.
5
Rotate the MENU Wheel to select “ENTER” and press it.
After “ENTER” blinks, all the images are deleted and the
Menu Screen reappears. Press the MENU Wheel in
again to close the Menu Screen.
•To cancel deletion, rotate the MENU Wheel to select
“CANCEL” and press it twice. The Menu Screen closes.
NOTES:
●
Before deleting some still images stored in memory, perform
“Protecting Images” for the necessary ones (
੬
pg. 32) or
save them on a PC so that you do not lose them accidentally
(
੬
pg. 34).
●
Protected images (
੬
pg. 32) cannot be deleted with the
above operation. To delete them, remove protection first.
●
If the remaining number of shots is not 30 in the FINE mode
or 60 in the STANDARD mode when “ALL” is selected on
the DELETE Menu, initialize the camcorder’s memory
(
੬
pg. 57).
Power Switch
Display
CAUTION:
While “ENTER” is selected on the Delete
Execute Menu and it is blinking, switching
off the camcorder or removing the power
supply unit (battery pack or AC Adapter)
may cause the camcorder’s built-in memory
to become corrupt. Never remove the
power supply unit at this stage.
MENU Wheel
REFRESH Button
DELETE Menu
In case of “ALL”
Delete Select
Menu
In case of
“SELECT”
Delete Execute
Menu
Menu Screen
Makes the DSC lamp
come on.