Filter
Top Products
VIDEO PLAYBACK
24 EN
MasterPage: Left
NOTES:
● It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
(੬ pg. 15)
● To monitor the picture and sound from the
camcorder without inserting a tape or memory
card*, set the camcorder’s Power Switch to “A” or
“M”, then set your TV to the appropriate input
mode.
* GR-DF470/450 only
● Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
The Full-Function Remote Control Unit can
operate this camcorder from a distance as well
as the basic operations (Playback, Stop, Pause,
Fast-Forward and Rewind) of your VCR. It also
makes additional playback functions possible.
(੬ pg. 25)
Installing The Battery
The remote control uses
one lithium battery
(CR2025).
1 Pull out the battery
holder by pushing the lock
tab.
2 Insert the battery in the
holder, and be sure to
have the “+” mark visible.
3 Slide the holder back in until you hear a click.
Beam Effective Area (indoor use)
When using the remote
control, be sure to point it
at the remote sensor.
The transmitted beam’s
approximate effective
distance for indoor use is
5 m (16 ft).
NOTE:
The transmitted beam may not be effective or may
cause incorrect operation when the remote sensor
is directly exposed to sunlight or powerful lighting.
Buttons And Functions
A Infrared beam transmitting window
● Transmits the beam signal.
The following buttons are available only when
the camcorder’s Power Switch is set to “PLAY”.
B PAUSE Button
● Pauses the tape (੬ pg. 25)
Up Button (੬ pg. 26)
C SLOW Rewind Button (੬ pg. 25)
D REW Button
● Rewind/Reverse Shuttle Search on a tape
(੬ pg. 22)
● Displays previous file in a memory card*
(੬ pg. 29)
Left Button (੬ pg. 26)
Playback Using The Remote
Control
1
1
2
3
3
Lock tab
Remote sensor
GR-DF470-450US.book Page 24 Tuesday, January 25, 2005 12:14 PM