Filter
Top Products
15
No. Item Description
③
Record Status
[Set values :
ON,
OFF]
[Status : No Recording
, Recording
]
This is only enabled when the SD card status is "Use" and the format status is
"Format complete".
When recording, the status changes to [Recording]. When recording is stopped,
the status changes to [Stopped]. When only alarm recording is selected, the
status is [Stopped] at times other than when the alarm is engaged.
Check "ON" and check one of the available settings in "Recording image quality
settings" to begin continuous-loop recording to the SD card with the selected
recording quality.
Starts continuous-loop recording to the SD card with the selected recording
quality.
If you push [OK] when the encoding setting has not been set, the "Select an
encoding setting." dialog is displayed and recording does not start.
Select "OFF" and click the [OK] button to stop recording.
Recording
image quality
To change the recording image quality, select "OFF" for ③ Record Status, push
the [OK] button to stop recording, and then configure settings.
If you push [OK] when the recording image quality has not been set, the "Set the
recording mode." dialog is displayed and recording does not start.
You can select either "Constant", "Alarm", or both settings.
Memo
：
z When the record status is "ON", the setting for Recording image quality cannot
be changed.
Constant
Constantly records to the SD card.
④
Alarm
SD card recording is performed when conditions set for the alarm setting items
are met. The alarm event recording interval for when an alarm is triggered is from
60 seconds before the trigger (pre-trigger) to 60 seconds after the trigger
(post-trigger), for a total of 120 seconds.
Memo
：
z Even if another trigger is detected within 60 seconds of the first trigger, it will
not appear in the event list.
z If another trigger is detected during alarm recording, recording is extended 60
seconds from the original end point.
z If less than 60 seconds have passed since video recording was initially started,
the pre-trigger time will be less than 60 seconds.
* The [Set values] in bold letters are factory defaults
Alarm recording-related setting items are displayed when "Alarm" is selected.