Filter
Top Products
2
1 Introduction
Thank you for purchasing the camera. Before installing it, please verify your model and read this guide carefully. See the
INSTRUCTIONS located on CD-ROM for more information about setting up your camera.
Unpack Everything
• HD IP CAMERA
• WARRANTY CARD
• SAFETY PRECAUTIONS
• QUICK GUIDE
• 8-PIN TERMINAL BLOCK for alarm input/output
• CD-ROM containing INSTRUCTIONS and IP Finder software
Prepare for Installation
Select the lens to use with your camera. This camera supports the use of a manual iris or DC iris
lens. When using a DC iris lens, it should be connected to the camera via the 4-pin square socket
located at the side of the camera.
Mount the Camera
1. Attach the camera to a pending mount.
Insert the screws on the camera stand into either of the screw holes on the base. Then tighten
them up.
2. Mount the camera onto the ceiling/wall and fasten it securely.
3. Connect the Safety Wire(Fall Prevention Wire, not supplied) to the camera and the wall/ceiling.
To prevent the camera from falling off, ensure that it is connected to a firm place
(ceiling slab or channel) using a Safety Wire (Fall Prevention Wire is not
supplied).
Warning
Pay also careful attention to the length, strength, wiring, and material (insulating
properties) of a Safety Wire (fall prevention wire) to be used. The length should
be as short as possible within the permissible range of the mounting length. The
wire should be strong enough to withstand the total weight of this product and the
fixer. (Pay also attention to the finishing at the end of the wire.)
Caution
Must be isolated camera and the wall/ceiling which are connected by a Safety
Wire (Fall Prevention Wire).