Filter
Top Products
4
Getting Started
Thank you for purchasing this product. (These instructions are for WB-1540U/ WB-1550U)
Before beginning to operate this unit, please read the instruction manual careully in order to make sure that the best possible
performance is obtained.
Getting Started
Table of Contents ...................................................................4
Operating Precautions ...........................................................4
System Example ....................................................................5
VN-C625U and VN-C655U Systems .................................5
TK-C625U/E, TK-C655E and TK-C676E Systems ............5
Installation and Connection (WB-1540U)
Disassembling the Housing ....................................................6
Mounting the Camera ............................................................6
TK-C625U/E ......................................................................6
VN-C625U .........................................................................7
Assembling the Housing ........................................................8
Mounting the Housing to the wall ...........................................8
Installation and Connection (WB-1550U)
Disassembling the Housing .................................................10
Procedures Before Mounting the Camera ...........................10
Mounting the Camera .........................................................11
TK-C655E and TK-C676E .............................................. 11
VN-C655U .......................................................................12
Assembling the Housing ......................................................13
Mounting the Housing to the wall ........................................ 13
Others
Specifications ......................................................................15
WB-1540U ......................................................................15
WB-1550U ......................................................................15
Ⅵ Depending on the installation environment of this unit, the
life span of the attached camera may decrease significantly.
Give close attention to the installation location (especially if
used continuously under high temperature or in locations
constantly exposed to direct sunlight).
Ⅵ As the interior of this unit will heat up, be sure to use San
Disk (industrial) if loading the CF card to VN-C625U.
Ⅵ This unit may stop functioning properly due to natural
hazards as it is to be installed outdoors. To take
photographs properly, be sure to perform daily checks.
Ⅵ Do not install this unit in locations with sharp temperature
changes, such as near air-con compressors or exhaust-
pipes. Condensation may occur inside the attached
combination camera.
Ⅵ To save energy, switch off the system when not in use.
Ⅵ For safety reasons special techniques are necessary for
installation. Consult your dealer regarding installation, and
ensure that it is carried out by a specialist.
Ⅵ Be sure to mount the safety wire for safety purposes. If it
falls, it may cause injury or accidents.
Ⅵ Taking vibrations, mass and wind force into account, ensure
to mount in a location with sufficient strength using solid
anchor bolts. If reinforced or spiral nuts are not tightened
enough, picture blurring may occur on the monitor screen
due to vibration, and in the worst case there is a danger of
falling.
Ⅵ Use at the voltage indicated. A voltage other than that
displayed may result in fire or electric shocks.
Ⅵ This unit supports lightning conduction to the connection
cable to some extent, but not fully. At installation locations
where there may be a lightning hazard, be sure to add an
arrester to the connection cable or take other precautions.
Ⅵ Do not dangle, shake, or hook objects. If too much load is
placed on top, it may fall and cause injury or accidents.
Ⅵ If a ball or bird hits this unit, bringing about some sort of
trouble, consult your dealer or the nearest Victor service
center.
Ⅵ Do not modify this unit yourself. Accidents may result.
Ⅵ Do not install in locations where there may be vibrations or
impact. If it falls, it may cause injury or accidents.
Ⅵ Regularly check for the deterioration of attaching parts and
the loosening of the screws caused by vibrations. If it falls, it
may cause injury or accidents.
Ⅵ Do not install in locations where radiation, X-rays, or
corrosive gases are emitted. Doing so may cause the
camera to malfunction.
Ⅵ Keep all packaging out of the reach of children. If used for
play, it may cause injury or suffocation.
The compatible cameras for each housing are as follows:
● WB-1540U: TK-C625U/E,VN-C625U
● WB-1550U: TK-C676E,TK-C655E,VN-C655U
Table of Contents
Operating Precautions
Ⅵ This installation should be made by a qualified service
person and should conform to all local codes and the
National Electrical Code , ANSI/NFPA 70.
WB-1540_1550.book Page 4 Thursday, May 17, 2007 3:21 PM