Filter
Top Products
7
Using Your Snugasabug
®
Tie-Down
Electric Blanket
Before First Use
Remove any promotional material
and packaging from the electric
blanket.
Securing Your Tie-Down
Electric Blanket
Place the electric blanket on the
mattress towards the foot of the bed.
Leave sufficient room for the pillow
and ensure the control leads are near
the head of the bed. Remove tags
from tie tapes. Pass the middle tie
tape under the middle of the mattress
and through the middle loop on the
opposite side. Tie tightly.
Pass end tape under the bottom
corner of the mattress and through
the end loop, then down under
the opposite bottom corner of the
mattress and through the bottom side
loop. Tie tape firmly.
Repeat procedure for the tape at the
top end of the mattress. The electric
blanket should now be firmly taped to
the mattress as shown in Fig 3.
To Connect The Controller
Your blanket has a detachable
controller and waterproof element
which makes your blanket machine
washable.
Ensure the electric blanket controller
is in the ‘OFF’ position and not
connected to the 230V or 240V power
supply.
To connect your controller, thread the
detachable plug from the controller
and plug it fully into the socket.
Ensure that the locking clip engages
with the small plastic pin on the plug.
Turn the electric blanket over, position
and fit it to the mattress.
To Detach The Controller
The socket has a locking clip that
engages with a small pin on the plug.
With the controller set to the ‘OFF’
position indicated by a ‘0’ and power
plug removed from the 230V or 240V
power supply, push the clip out to
release the socket pin and withdraw
the connector plug by pulling it away
from the socket.
Fig. 1
Fig. 3
Fig. 2
KEB302_IB_FA.indd 7 12/10/09 10:13 AM