Filter
Top Products
-8-
4. To Setup Mass Storage Driver / KanguruShield. Insert the Driver CD into your CD-ROM drive.
Run KanguruShield.exe from the CD, this will install the security utility along with the necessary
Windows drivers. Follow the on screen instructions.
5. Plug the Kanguru Flash Drive (Max) into the USB Hi-Speed port. If you need to, use the USB
extension cable.
6. Windows will start searching and installing the drivers.
7. After the installation has complete, check for proper installation. To do this, go to Control Panel >
System > Hardware > Device Manager. Make sure that the new drive is listed under Disk Drives
section
8. Congratulations! Your Kanguru Flash Drive (Max) is ready.
For Windows ME/2000/XP Setup
1. Start up the computer and boot into Windows.
2. Normally your machine will be ready to install new hardware. However, if you are using Windows
2000 or XP and are unable to install new hardware, you might not have Administrator privileges.
Please check with your computer manufacture or your computer administrator to receive advice on
how to install new hardware device.
3. For optimum usability and compatibility, please make sure you have the latest driver for your USB
2.0 Hi-Speed ports. If you are using Windows 2000 or XP, we recommend you use Microsoft USB 2.0
driver.
4. To setup KanguruShield. Insert the Driver CD into your CD-ROM drive. Run KanguruShield.exe
from the CD, this will install the security utility. Follow the on screen instructions to setup the security
utility.
5. Plug the Kanguru Flash Drive (Max) into the USB 2.0 Hi-Speed port. If necessary, use the USB
extension cable.
6. Windows will start searching and installing the drivers.
7. After the installation has completed, check for proper installation. To do this, go to Control Panel >
System > Hardware > Device Manager. Make sure that the new drive is listed under Disk Drives
section
8. Congratulations! Your Kanguru Flash Drive (Max) is ready.
* If the device does not work, please see Q6 of PC USB Hi-Speed FAQ.