Filter
Top Products
4-2
Operating the Printer
Using Setup Mode to Review Printer Settings
Use the operator panel to review printer settings in Setup mode.
Accessing the Printer
Settings
Press Menu repeatedly to scroll through the printer settings in the following
order.
Menu Advance
Paper
Enter
Paper
Rewind/Clear
Error
Ready
Power
Photo Printer 6800
Kodak
1. Press Menu to enter Setup Mode.
2. Press Menu repeatedly to scroll
through the printer settings.
Printer settings
are displayed here
3. Press +/- to scroll through selections.
5. Press Clear to exit Setup Mode.
4. Press Enter to initiate an action
or accept a change.
3
1,2
4
5
Printer Setting Operator Panel
Display
Action Required
Printer ready Ready None. The printer is on and ready to make prints.
Making a test print Test Print Mode Press enter to make a test print. See “Making a Test Print” on
page 1-10.
Check remaining
paper status
Remain = XXX/YYY None. XXX represents how many remaining prints you can make
with the current paper roll. YYY represents the total number of
prints on a paper roll. The counter is reset each time you press
Paper Rewind.
Checking the ribbon
status
DonorRemain = XX[%] None. XX[%] represents the percentage of the installed ribbon that
is available for making prints.
Checking the printer
total print count
Printed = XXXXX None. XXXXX represents the total number of prints made since the
printer was manufactured. This counter cannot be reset.
Checking the printer
firmware version
Main Firm = None. The printer control firmware version number is displayed.
Checking the image
processing firmware
version
DSP Firm = None. The image processing firmware version is displayed.