Filter
Top Products
2 Using the KODAK PROFESSIONAL READYLOAD Single-Sheet Packet • E-2549
INSTRUCTIONS
Using KODAK PROFESSIONAL READYLOAD
Single-Sheet Packets in the KODAK PROFESSIONAL
READYLOAD Packet Film Holder
To expose the film, follow these steps:
1. Grasp the end of the packet and insert it into the
holder until it comes to a firm stop.
2. When you are ready to expose the film, grasp the end
of the outer protective envelope as shown and pull it
out until it stops. You should see part of the stop zone.
Do not squeeze the release bar during this step.
3. Expose the film as you normally do.
4. Push the outer envelope all the way into the holder
until it comes to a firm stop. Do not squeeze the
release bar during this step.
5. To remove the packet from the holder, squeeze and
hold the release bar. Then grasp the end of the packet
as shown, and pull it straight out. Do not bend the
packet when you remove it from the holder.
Stop Zone
6. Wrap an “Exposed” sticker around the end of the
packet with the metal clip.