Troubleshooting
www.kodak.com/go/support
43
Picture quality problems
Direct printing (PICTBRIDGE enabled Printer) problems
Status Solution
Picture is not clear
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ Clean the lens (see page 50).
■ Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
Picture is too dark
■ Reposition the camera for more available light.
■ Use Fill flash (see page 7) or change your position so light is not
behind the subject.
■ Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
page 48.)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
Picture is too light
■ Reposition the camera to reduce the amount of available light.
■ Turn the flash off (see page 7).
■ Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
page 48.)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ In Program and Panorama modes, adjust the Exposure
Compensation (see page 26).
Status Solution
Cannot find the
desired picture
■ Use the Direct printing menu to change the image storage location
(see page 35).