Filter
Top Products
48 www.kodak.com/go/support
Troubleshooting
Direct printing (PictBridge) problems
Picture is too light
■ Reposition camera to reduce the amount of available light.
■ Turn flash off (page 9).
■ Move so that the distance between you and the subject is within the
effective flash range (page 9).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■ Use P mode to adjust the Exposure.
Picture is not clear
■ To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■ Clean the lens (page 58).
■ Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■ Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
If Try one or more of the following
Cannot locate desired picture.
■ Turn on the camera. Make sure the camera is not in
Favorites mode.
■ Use the Direct print menu to change the image
storage location.
The Direct print menu interface
turns off.
Press any button to redisplay the menu.
Cannot print pictures.
■ Ensure that there is a connection between camera
and printer (page 41).
■ Ensure the printer and camera have power.
If Try one or more of the following