Filter
Top Products
VP-790 Blending Images – Setting the Basic System 5
2. Select the horizontal grey bars test pattern in one of the two following ways:
Exit the OSD menu and use the up/down arrow buttons on the front
panel to cycle through the available patterns
In the top OSD menu select Input, and then Test Pattern Setup and Test
Pattern. Select Grey H Bars
2.1.3 8BSetting the Position in the Matrix
Define the position of each VP-790 unit in the matrix:
1. From the Setup menu, set the Operation Mode to Multiunit.
Figure 4: Multiunit Screen
2. Set a 2 x 1 matrix system:
Set Units Wide to 2
Set Units High to 1
3. Define the position of each VP-790 unit separately:
Select the H-Position on the VP-790 unit connected to the left hand
projector to 0
Select the H-Position on the VP-790 unit connected to the right hand
projector to 1