Filter
Top Products
Control Buttons
9
LW1001 and LW1002
Control Buttons
1. AUTO BUTTON – When the receiver is set to AUTO Mode, it will continuously switch between
connected cameras. The dwell time is set to 4 seconds per camera (by default), however this can be
adjusted to 2~30 seconds.
• LW1001/ LW1002/ LW1010 /LW1012: To adjust the dwell time, press
and hold both the AUTO and MANUAL buttons at the same time – this
will produce beeps indicating one second increments. Once the
desired dwell time has been reached, release the buttons.
• LW1020/LW1022: To adjust the dwell time, press and hold both the
AUTO and MANUAL buttons at the same time. Hold both buttons
pressed for the amount of time the dwell time needs to be set to.
Once the desired dwell time is reached, release both buttons and the
indicator light on the receiver will show the dwell time by blinking 1
time for each second of dwell time
2. MANUAL BUTTON – Press the MANUAL button to switch between
available cameras manually. The Receiver will switch to a different camera (if
available and configured) each time the MANUAL button is pressed.
Wireless Receiver Installation
Installing the wireless receiver (for LW1001, LW1002, LW1010, LW1012, LW1020, and LW1022)
For connecting to a TV/monitor <OR> recording on a VCR/DVD recorder.
1. Connect the AV Cable to the back of the receiver. Connect the other end of the Cable to the
Video IN (Yellow) and Audio IN (White) ports on the TV, VCR or other viewing/recording devices
with RCA inputs.
2. Plug the Receiver power cable into the 9V POWER input (5V for LW1020/LW1022). Plug the
power cable into a wall outlet.
3. Place the receiver in a place that will have clear reception to your camera(s). Try to avoid placing
the receiver near other 900MHz devices (such as older cordless phones, wireless headphones,
etc.).
NOTE: Do not force the antennas past their locked positions, or damage may occur to the
Receiver or Camera.
Installing the wireless receiver (for LW1020 and LW1022 ONLY)
For viewing on your PC <OR> remotely through a web browser.
4. Connect one end of the USB Cable into the Receiver and the other end into a computer. Please
refer to the Quick Start Guide to install the driver and Yoics. For additional Yoics information or
advanced Yoics user options, Please visit the website at www.yoics.com
LW1010, LW1012,
LW1020
,
and LW1022