Filter
Top Products
Adding Cameras
14
Adding Cameras
The System comes with a camera that has already been paired. The Pairing Function
assigns each camera to a different channel on the Wireless Receiver (up to four cameras), and
is necessary for configuring additional cameras. By default, the camera included with the
system appears on channels 1 on the wireless receiver.
NOTE: It is highly recommended to pair the cameras to the receiver before permanently
mounting the cameras.
1. Connect the power cable from the camera to
the Power Adapter; plug the Power Adapter into
an outlet or surge protector.
2. Press the CHANNEL button on the Wireless
Receiver to select an empty channel.
3. Press and hold the CHANNEL button for 5
seconds to activate pairing function. The on-
screen displays informs you that you have 30
seconds to press the pair button on the camera
(see Figure 5.1).
4. Press and hold the Pair button underneath the
antenna on the back of the camera. You must
press the Pair button on the camera within 30
seconds of pressing the Pair button on the
Wireless Receiver. If pairing is successful, live
video from the camera will immediately appear
on the monitor.
Using Auto-Scan
Auto-Scan automatically switches between channels 1~4.
Press the CHANNEL button on the wireless receiver to
turn on Auto-Scan (CH1~4>Quad,>Auto-Scan).
You can also disable Auto-Scan for individual channels. This
allows you to customize viewing of the connected cameras.
To disable Auto-Scan:
1. Make sure the Wireless Receiver and cameras are fully
connected and powered on.
2. Press the CHANNEL button to select the channel you
wish to remove from Auto-Scan.
3. Press and hold the RESOLUTION button until the on-
screen display indicates that Auto-Scan has been
turned
OFF
for that specific channel.
NOTE: Repeat step 3 to turn Auto-Scan ON.
Figure 5.0 Hold the CHANNEL button to
pair additional cameras
Figure 5.1 Pair button underneath
antenna
Figure 6.0 Auto-Scan turned OFF for
Channel 1.