Filter
Top Products
Setting Dwell Time
15
Setting Dwell Time
You can set the length of time (in seconds) that the receiver displays each channel while in Auto
Scan.
To set dwell time:
1. Make sure the Wireless Receiver and
cameras are fully connected and powered
on.
2. Press and hold the RESOLUTION button
and CHANNEL button
at the same
until
the Dwell Time screen appears. Continue
holding both buttons.
3. With the CHANNEL button and
RESOLUTION button held down, the
receiver will automatically cycle the dwell
time from 1~20 seconds. The higher the
dwell time, the longer each channel
remains on-screen during Auto-Scan.
4. Release both buttons to set the desired
dwell time.
NOTE: If you repeat this process, the Dwell
Time screen will display the last set dwell
time.
Figure 7.0 Press and hold the RESOLUTION
and CHANNEL buttons at the same time
Figure 7.1 Continue holding both buttons to
set the dwell time for Auto Scan