9
OPEN WATER APPLICATION
To locate fish, look for treasure or find that perfect spot, simply turn
thecamerapowerONanddroptheMantacameraintothewater.If
you’re drifting with the wind or using a trolling motor with the VS820,
attach the supplied trolling fin to the rear of the Manta Camera for
added stability. The internal weight is enough to keep the camera
down while the fin assists in keeping the Manta camera tracking
straight through the water. If the camera becomes hung up, back
up from the direction you were traveling from and slowly try to back
the camera out of the snag. DO NOT pull directly upward with force
unless all other avenues have been pursued.
BATTERY CHARGING
Rechargingthebatteryaftereveryuseisrecommended.Thecharger
thatwassuppliedwiththeVS820isa1-amptwo-stageDCcharger.
To charge your system, simply connect the positive (red) and
negative (black) female connector from the charger to the positive
(red)andnegative(black)maleendatthebattery.Onceconnected,
plugthechargerintoa110voltACwalloutlet.TheLEDindicator
light on the charger will be red when the charger is in a charging
mode.TheLEDindicatorlightonthechargerwillturngreenwhen
thechargerswitchestoatricklecharge.The7.2amphour,12-volt
battery that was supplied with the VS820 system should take about
8to10hourstochargefromacompletelydischargedstate.
WhenthegreenLEDlightison,disconnectthechargerfromthe
batteryandwalloutlet.IfthegreenLEDlightdoesnotcomeon
after10to12hoursofchargingtimeorthegreenLEDlightcomes
on relatively soon after the charger is plugged in, this may indicate
that the battery will not accept a full charge. If this occurs and your
camera run time is greatly diminished, you may want to replace the
batterywithabatteryofequalspecification.
Ifyourviewingimageappearscloudy,fuzzyorthescreenbegins
toshrink,checkyourbatterycharge.Oneofthemajorsymptoms
ofadeadornear-deadbatteryisthedegradationofyourviewing
image. Try charging your battery or if the battery is unable to hold
a charge, replace it with a new one of similar specification. If you
need to remove the battery, unplug the two battery terminals from the
battery.RemovetheVelcrostrapthatisholdingthebatteryinplace
and lift the battery out. To replace the battery, place a new battery
into the battery compartment and secure it with the Velcro strap and
re-connectthepositiveandnegativeterminals. MarCum does not