Marcum Technologies VS820 Film Camera User Manual


  Open as PDF
of 16
 
5
the camera housing. The amount of weight is ideal for trolling at
lowspeedsorkeepingthecameratrackingsmoothincurrent.For
added open water stability or to use as a down view camera, the
fin (included) snaps into the rear of the Manta camera housing with
ease.
FollowingMarCum’sstandards,theVS820isprotectedwithastylish
reinforced padded soft pack case. Under the soft pack is a molded
ABShardcasewithabuiltinbatterytrayandaVelcrostrapto
securelyholdthebatteryinplace.Nexttothebatteryisastorage
compartment for the camera and camera cable. The monitor folds
down flat and the padded case encompasses the entire system
protectingitduringtransportation.Ontheleftsideofthecaseisa
carrying handle for ease of transport.
Thesealed7.2amprechargeablelead-acidbatterycanprovideup
to8hoursofcontinuoususeduringidealconditions.Batteryruntime
will vary depending on the condition of the battery, use of underwater
LEDlighting,levelofscreenbacklight(brightness)andLCDheater
system.The1amp,two-stagechargerwillquicklychargethebattery
backtofullcapacity.Oncecharged,asmallgreenLEDlightwillbe
illuminated to indicate the charger has switched to a trickle charge
mode.
The VS820 offers a full one year warranty backed by MarCum’s
first-ratecustomerservice!
GETTING STARTED
TheVS820hasbeenset-upandtestedatthefactorybeforebeing
placed into its retail packaging.
RemovetheVS820fromthepackagingandplaceonalevelsurface
with the MarCum Technologies logo facing towards you and right side
up.OpenthetopcoverofthesoftpackbyliftingupontheVelcro
closersoneachsideandfrontofthesoftpack.Onceopened,loosen
the knobs on the either side of the gimbal bracket (at the base of
themonitor)byturningeachonecounter-clockwise.Makesureto
loosen the knobs a considerable distance. Than depress both knobs
by pushing inwards and hold in place. This releases the lock on the
monitor angle. While depressing the knobs with the base of your
palms, use the index fingers of each hand and gently lift the monitor
up to the desired viewing position and release tension on the gimbal
knobs.Onceyouhavesetthemonitortothedesiredviewingangle,
 previous next