Marcum Technologies VS825 Digital Camera User Manual


 
Nature Vision, Inc. www.marcumtech.com
- 6 -
base of the monitor) by turning each one counter-clockwise. Make sure to loosen the
knobs a considerable distance. Than depress both knobs by pushing inwards and hold
in place. This releases the lock on the monitor angle. While depressing the knobs with
the base of your palms, use the index fingers of each hand and gently lift the monitor
up to the desired viewing position and release tension on the gimbal knobs. Once you
have set the monitor to the desired viewing angle, gently tighten the knobs until they
are snug. The battery, camera and cable are now accessible behind the monitor. It’s
easiest to remove the Velcro straps and unzip the soft pack case. The battery cable
connectors can now be connected to the battery by attaching the corresponding wire
colors to the correct terminal. The positive (red) wire from the monitor can be
connected to the positive (red) terminal on the battery. The negative (black) wire
coming from the monitor can be connected to the negative (black) terminal on the
battery. After the terminals have been connected, the VS825c is ready for use. (Note:
The battery leads should stay connected at all times other than while charging. This
will be covered later in the charging process.)
To turn ON the VS825c, press the power key which is located on the keypad on lower
left side on the front of the monitor. After pressing the power key, a small red LED
indicator light – located next to the power button - will turn ON. The monitor should
now be displaying the image being transmitted from the camera. The camera can now
be unwrapped from the cable spool and deployed into the water to the desired depth.
The depth of field (distance the camera can see underwater) depends on the clarity of
the water and available light at the depth the camera is used. In clear water, the depth
of field can be many feet but in cloudy or muddy water the depth of view can be
reduced to only a few inches due to particles suspended in the water. Dirty or muddy
water and/or low light penetration can detract from the quality of the color picture.
Optimum color quality will result from clear water and adequate light penetration.
Adjusting the Monitor Settings
The VS825c monitor has four different adjustments that can be made by utilizing the
on-screen display. These adjustments can be made to enhance the image on the
monitor to the user’s preference. (note: The VS825c has been pre-set with factory
defaults for normal viewing.) To access the settings menu, press the menu key on the
digital keypad. The settings menu will be displayed on the screen (note: if you wait too
long before selecting an adjustment, the menu screen will time out and disappear). To
change between on-screen adjustment choices (brightness, contrast, color,
sharpness), continue to press the menu key. The selected on-screen adjustment will
be highlighted on the LCD screen. To change the settings within a selected menu, use
the UP and DOWN arrows located on the far right of the digital keypad. You will see