Filter
Top Products
“TELE” flash on the LC display. Then press the “-”
key to set “WIDE”.
Use of the telephoto attachment (“TELE”)
When using the 85 mm telephoto attachment
(7 mm height) in front of the reflector, continue de-
pressing the pre-select key until “TELE” and /
or “WIDE” flash on the LC display. Then press the
“+” key to set “TELE”.
W
orking without an attachment
When using the flash unit without an attachment
continue depressing the pre-select key until
“TELE” and / or “WIDE” flash on the LC display.
Then press the “-” and “+” keys until “TELE” and
“WIDE” are simultaneously displayed.
The setting becomes instantly effective and is auto-
matically stored after 5 s. The display then indi-
cates either “WIDE” or “TELE” depending on the
setting. “WIDE” and “TELE” are no longer display-
ed after storage if no reflector attachment is used.
Please refer to the instructions in Chapter 3.
9.4 Flash exposure correction value EV
In various exposure situations it may be necessary
to specifically influence the flash intensity of the
slave flash unit, i.e. increase or decrease the inten-
sity. A corresponding flash exposure correction
value can be set on the flash unit for this purpose.
A flash exposure correction value can only
be set in the auto flash mode A!
Continue depressing the pre-select key on the
flash unit until “EV” and the correction value flash on
the display. While the displays are flashing set the
desired correction value between -3 and +3 EV- in
one-third increments. The setting becomes instantly
effective and is automatically stored after 5 s. After
storage the LC display shows again the f-stop in place
of the correction value and “EV” flashes to indicate
that an exposure correction value has been set.
To delete the correction value, set the correction
value “0.0” on the flash unit. “EV” ceases to be
displayed after automatic storage.
☞
103
ķ
703 47 0165.A1 Inh. 03.08.2004 7:38 Uhr Seite 103