Filter
Top Products
5756
Partial light output (P)
16. Technical Data
Example:
You intend to make a stroboscopic shot with 7 flash exposures at a frequency of
3 flashes per second.
Procedure:
After having completed the first six settings described in „Setting procedure for
stroboscopic mode“, press the button N and then enter the number of exposures
- in this case 7 - with the „+“ or „-“ button.Then press the button f(Hz),followed
by the entry of the flash frequency - in this case 3 - with the „+“ or „-“ button.
The maximum possible partial light output level is automatically adjusted to 1/16.
The partial light output level can also be manually adjusted to a smaller value.
The values specified in the tables only apply to fully charged NiCad
batteries or to new high power alkaline-manganese batteries. For
batteries that have been used it is necessary to adjust the next
smaller main partial light output level (e.g. adjust 1/16 instead of 1/8)
to ensure that the number of flashes is achieved with certainty.
16. Technical Data
T
able 5: Maximum partial light output levels in stroboscop
ic mode
2-4 1/8
5-7 1/16
8-12 1/32
13-20 1/64
Number of flashes (N)
☞
Camera shutter speed in seconds
Table 6: Camera shutter speeds in stroboscopic mode
1 2 44888815151530
2 1 22444488815
3 1 1222444488
4 1/21122224448
5 1/21112222244
6 1/21/2111222244
7 1/21/2111122244
8 1/41/21/211112224
9 1/41/21/211111224
10 1/41/21/21/21111122
15 1/4 1/4 1/2 1/2 1/2 1/2 1 1 1 1 2
20 1/8 1/4 1/4 1/4 1/2 1/2 1/2 1/2 1/2 1 1
30
1/15
1/8 1/4 1/4 1/4 1/4 1/2 1/2 1/2 1/2 1
Flash frequency
f(Hz)
(Flashes/sec.)
Number of flashes
2 3456789101520
You have now adjusted the number of flashes = 7 and the flash frequency = 3;
the maximum partial light output level of 1/16 has been adjusted automatically.
Table 6 shows you the aperture to be set on the camera.