Filter
Top Products
Getting Started
11
VueZone System
Sync Cameras to the Base Station
Syncing the cameras establishes communication between the cameras and the base station.
To sync cameras to the base station:
1 On the base station, make sure that the Internet LED on front is flashing.
The flashing Internet LED shows communication with the Internet. If the LED does not
flash, visit
http://support.netgear.com to troubleshoot, or contact VueZone support.
2 Place the camera within 12 inches (30.5 cm) of the base station.
3 Press and release the Sync button on the top of the base station.
The blue Sync LED on the base station lights for 45 seconds.
4 During this time, slide the camera On/Off switch to the on position (green dot showing).
The Sync LED on the front of the camera flashes for 5 seconds to confirm sync.
5 If the camera Sync LED did not flash within 45 seconds, power off the camera and try Steps
3 and 4 again.
6 Once synced, the camera can be viewed and positioned.
Tip: For a motion detection camera, each time the power is turned on it takes
2 minutes for its motion sensor to warm up and begin operating.
To register your base station:
1 Locate your VGN number on the base station label.
2 Follow the quick install guide instructions.
3 Visit http://vuezone.com/register to register.
4 Follow the onscreen instructions.