Nikon 13306 Digital Camera User Manual


 
237
U
❚❚ Commander Mode
Use the built-in flash as a master flash controlling one or more remote optional flash
units in up to two groups (A and B) using advanced wireless lighting (0 294).
Selecting this option displays the menu shown at right.
Press 4
or 2 to highlight the following options, 1 or 3 to change.
A The SB-400 and SB-300
When an optional SB-400 or SB-300 flash unit is attached and turned on, Custom Setting e3
changes to Optional flash, allowing the flash control mode for the optional flash unit to be
selected from TTL and Manual (Repeating flash and Commander mode options are not
available).
A “Times“
The options available for Repeating Flash > Times are determined by flash output.
Output Options available for “Times” Output Options available for “Times”
1/4 2 1/32 2–10, 15
1/8 2–5 1/64 2–10, 15, 20, 25
1/16 2–10 1/128 2–10, 15, 20, 25, 30, 35
Option Description
Built-in
flash
Choose a flash mode for the built-in flash (commander flash).
TTL
i-TTL mode.
Choose flash compensation from values between +3.0 and –3.0 EV in
increments of
1
/3 EV.
M Choose the flash level from values between 1/1 and 1/128 (
1
/128 of full power).
––
The built-in flash does not fire, although remote flash units do.
The built-in flash
must be raised so that it can emit monitor pre-flashes.
Group A Choose a flash mode for all flash units in group A.
TTL
i-TTL mode.
Choose flash compensation from values between +3.0 and –3.0 EV in
increments of
1
/3 EV.
AA
Auto aperture (available only with compatible flash units; 0 294).
Choose flash
compensation from values between +3.0 and –3.0 EV in increments of
1
/3 EV.
M Choose the flash level from values between 1/1 and 1/128 (
1
/128 of full power).
–– The flash units in this group do not fire.
Group B
Choose a flash mode for all flash units in group B.
The options available are the
same as those listed for Group A, above.
Channel
Choose from channels 1–4.
All flash units in both groups must be set to the same
channel.