Nikon 1540B Digital Camera User Manual


 
64
y
A HDMI
If the camera is connected to an HDMI device (0 204), the
view through the lens will appear both in the camera monitor
and on the HDMI device.
The indicators that appear in the
HDMI device during movie recording are shown at right.
The
camera monitor does not show the sound level or virtual
horizon; indicators in the monitor and on the HDMI device
can not be hidden or displayed using the R button.
To use
live view when the camera is connected to an HDMI-CEC device, select Off for HDMI >
Device control in the setup menu (0 205).
A Remote Cords
If Record movies is selected for Custom Setting g4 (Assign shutter button, 0 248), the
shutter-release buttons on optional MC-DC2 remote cords (0 298) can be used to start
movie live view and to start and end movie recording.
D Recording Movies
Flicker, banding, or distortion may be visible in the monitor and in the final movie under
fluorescent, mercury vapor, or sodium lamps or if the camera is panned horizontally or an
object moves at high speed through frame (for information on reducing flicker and banding,
see Flicker reduction, 0 252).
Jagged edges, color fringing, moiré, and bright spots may
also appear.
Bright bands may appear in some areas of the frame with flashing signs and
other intermittent light sources or if the subject is briefly illuminated by a strobe or other
bright, momentary light source.
When recording movies, avoid pointing the camera at the
sun or other strong light sources.
Failure to observe this precaution could result in damage
to the camera’s internal circuitry.
Note that noise (randomly-spaced bright pixels, fog, or
lines) and unexpected colors may appear if you zoom in on the view through the lens (0 55)
during movie live view.
Flash lighting can not be used during movie live view.
Recording ends automatically if the lens is removed, the mode dial is rotated, or a remote
control release mode is selected.
Live view may end automatically to prevent damage to the camera’s internal circuits; exit live
view when the camera is not in use.
Note that the temperature of the camera’s internal
circuits may rise and noise (bright spots, randomly-spaced bright pixels, or fog) may be
displayed in the following instances (the camera may also become noticeably warm, but this
does not indicate a malfunction):
The ambient temperature is high
The camera has been used for extended periods in live view or to record movies
The camera has been used in continuous release mode for extended periods
If live view does not start when you press the a button, wait for the internal circuits to cool
and then try again.