Filter
Top Products
384
n
D Notes on Optional Flash Units
Refer to the flash unit manual for detailed instructions.
If the unit
supports CLS, refer to the section on CLS-compatible digital SLR
cameras.
The D800 is not included in the “digital SLR” category in the
SB-80DX, SB-28DX, and SB-50DX manuals.
i-TTL flash control can be used at ISO sensitivities between 100 and 6400.
At values over 6400, the desired results may not be achieved at some
ranges or aperture settings.
If the flash-ready indicator blinks for about
three seconds after a photograph is taken, the flash has fired at full
power and the photograph may be underexposed. View the
photograph in the monitor; if it is underexposed, adjust aperture, ISO
sensitivity, or the distance to the subject and try again.
When an SC-series 17, 28, or 29 sync cable is used for off-camera flash
photography, correct exposure may not be achieved in i-TTL mode.
We
recommend that you select standard i-TTL flash control.
Take a test shot
and view the results in the monitor.
In i-TTL, use the flash panel or bounce adapter provided with the flash
unit.
Do not use other panels such as diffusion panels, as this may
produce incorrect exposure.