Filter
Top Products
F10
Technical Notes and Index
Camera turns off
without warning.
• The camera automatically turns off to save
power (auto off function).
• The camera or battery has become too cold
and cannot operate properly.
• The inside of the camera has become hot.
Leave the camera off until the inside of the
camera has cooled, and then try turning it
on again.
• The camera turns off if the USB cable
connecting it to a computer or printer is
disconnected. Reconnect the USB cable.
23
F4
–
92, 95,
E23
Monitor is blank.
• The camera is off.
• The camera has entered standby mode to
save power. Press the power switch,
shutter-release button, A button, c
button, or b (e movie-record) button.
• The flash lamp flashes while the flash is
charging. Wait for the flash to charge.
• The camera and computer are connected
via the USB cable.
• The camera and TV are connected via an
HDMI cable.
• Camera and smart device are connected
using Wi-Fi connection and the camera is
operated by remote control.
22
23
48
92, 95
92,
E21
89
Monitor is hard to
read.
• Adjust the monitor brightness.
• The monitor is dirty. Clean the monitor.
76,
E65
F7
Date and time of
recording are not
correct.
• If the camera clock has not been set, the
“Date not set” indicator flashes during
shooting and movie recording. Images and
movies saved before the clock is set are
dated “00/00/0000 00:00” or “01/01/2014
00:00” respectively. Set the correct time and
date from the Time zone and date option
in the setup menu.
• The camera clock is not as accurate as
ordinary watches or clocks. Periodically
compare the time of the camera clock with
that of a more accurate timepiece and reset
as required.
18, 76,
E63
Problem Cause/Solution A