Nikon 26496 Digital Camera User Manual


 
21
Step 1 Turn the Camera On
Basic Steps for Shooting and Playback
Turning the Camera On and Off
When the camera is turned on, the power-on lamp (green) will light, and then
the monitor will turn on (the power-on lamp turns off when the monitor turns
on).
To turn off the camera, press the power switch. When the camera is turned off,
both the power-on lamp and the monitor turn off.
To turn on the camera in playback mode, press and hold the c (playback)
button. The lens will not extend.
C Power Saving Function (Auto Off)
If no operations are performed for a while, the monitor will turn off, the camera will enter standby
mode, and the power-on lamp will flash. If no operations are performed for approximately another
three minutes, the camera will turn off automatically.
To reactivate the monitor while the power-on lamp is flashing, press any of the following buttons:
- Power switch, shutter-release button, A (shooting mode) button, c (playback) button, or b
(e movie-record) button.
The time allowed to elapse before the camera enters standby mode can be changed from the
Auto off option (A87) in the setup menu (A86).
By default, the camera enters standby mode in about one minute when you are using shooting
mode or playback mode.
When the AC Adapter EH-62G (available separately) is used, the camera enters standby mode after
30 minutes (fixed).
9 50950
8 m 0 s8 m 0s
Flashes
No operations
performed
No
operations
performed
3 min
Camera enters standby
mode
Camera turns off