Nikon AW100 Digital Camera User Manual


 
81
Recording Movies
Recording and Playing Back Movies
B Notes on Movie Recording
When saving a movie onto a memory card, a memory card with an SD speed class of Class 6 or
higher is recommended (A21). If the transfer speed of the card is slow, the movie recording may
end unexpectedly.
Using the digital zoom causes image quality to deteriorate. If you start recording the movie
without using digital zoom, and you keep pressing the zoom button g, the zoom stops at the
maximum optical zoom ratio. Release the zoom button and press again g to trigger digital zoom.
When recording ends, digital zoom turns off.
The sound using the zoom, autofocus, vibration reduction or aperture control when the
brightness changes may be recorded.
The following phenomena may be seen on the monitor while recording movies. These
phenomena are saved in the recorded movies.
- Banding may occur in images under fluorescent, mercury-vapor, or sodium-vapor lighting
- Subjects that move quickly from one side of the frame to the other, such as a moving train or
car, may appear skewed
- The entire movie image may be skewed when the camera is panned
- Lighting or other bright areas may leave residual images when the camera is moved
B Notes on Autofocus
When Autofocus mode (A83) in the movie menu is set to A Single AF (default setting),
the focus is locked when the b (e movie-record) button is pressed to start movie recording.
Autofocus may not perform as expected (A31). Should this occur, try the following:
1. Before recording, set
Autofocus mode
in the movie menu to A Single AF (default setting).
2. Position a different subject at the same distance in the middle of the screen. Press the b
(emovie-record) button to start the movie recording, and change the composition.
B Notes on the Camera Temperature
The camera may become warm when recording movies for an extended period of time or when
the camera is used in a hot area.
When the temperature inside the camera becomes extremely
high while recording a movie, recording automatically stop after
30 seconds. The remaining amount of recording time (B30 s) is
displayed on the monitor. The camera turns off in 5 seconds after
movie recording automatically stops.
Leave the camera off until the inside of the camera has cooled
and then use it.
7m23s
7m23s
7m23s