Filter
Top Products
Technical Notes
141
The battery
inserted in the
camera cannot be
charged.
• Confirm all connections.
• When connected to a computer, the camera may
not charge for any of the reasons described
below.
- Off is selected for Charge by computer in
the setup menu.
- Battery charging stops if the camera is turned
off.
- Battery charging is not possible if the camera’s
display language and date and time have not
been set, or the date and time were reset after
the camera’s clock battery was exhausted. Use
the Charging AC Adapter to charge the
battery.
- Battery charging may stop when the computer
enters sleep mode.
- Depending on the computer specifications,
settings, and status, battery charging may not
be possible.
8
76, 115
–
10, 11
–
–
The monitor is
hard to read.
• Adjust the monitor brightness.
• The monitor is dirty. Clean the monitor.
108
135
O flashes on the
screen.
• If the camera clock has not been set, O flashes
on the shooting screen, and images and movies
saved before the clock is set are dated “00/00/
0000 00:00” and “01/01/2015 00:00” respectively.
Set the correct time and date for Time zone and
date in the setup menu.
• The camera clock is not as accurate as ordinary
watches or clocks. Periodically compare the time
of the camera clock with that of a more accurate
timepiece, and reset as required.
4, 106
Date and time of
recording are not
correct.
No indicators
displayed in
monitor.
Hide info is selected for Photo info in Monitor
settings in the setup menu.
108
Date stamp not
available.
Time zone and date has not been set in the setup
menu.
106
Date not stamped
on images even
when Date
stamp is enabled.
• The current shooting mode does not support
Date stamp.
• A function that restricts the date stamp is
enabled.
•
The date cannot be stam
ped
on movies.
110
56
–
Problem Cause/Solution A