Nikon COOLPIXL820BLK Digital Camera User Manual


 
56
Shooting Features
B Lowering the Flash
Push the flash down gently to lower the flash until it clicks into place when not in use (A 5).
C The Flash Lamp
The flash lamp indicates the status of the flash when you press the
shutter-release button halfway.
On: The flash fires when a picture is taken.
Flashing: The flash is charging. The camera cannot take pictures.
Off: The flash does not fire when a picture is taken.
If the battery level is low, the monitor turns off while the flash is charging.
C The Flash Mode Setting
The setting varies with the shooting mode.
“Available Features” (A 53)
“Default Settings” (A 62)
Some settings cannot be used with other functions (A 66).
The flash mode setting applied in A (auto) mode is saved in the camera’s memory even after the
camera is turned off.
C Effective Range of the Flash
When ISO sensitivity is set to Auto, the flash has a range of approx. 0.5–6.0 m (1 ft 8 in.–19 ft) at the
maximum wide-angle zoom position and a range of approx. 1.5–6.0 m (5–19 ft) at the maximum
telephoto zoom position.
C Red-eye Reduction
This camera uses “Advanced Red-Eye Reduction (In-Camera Red-Eye Fix).”
Pre-flashes are fired repeatedly at low intensity before the main flash, reducing the red-eye effect.
Additionally, if the camera detects red eye while saving an image, the affected area is processed to
reduce red-eye before the image is saved.
Note the following when shooting:
Because pre-flashes are fired, there is a slight lag between when the shutter-release button is
pressed and when the shutter is released.
More time than usual is required to save images.
Red-eye reduction may not produce the desired results in all situations.
In rare cases, areas of the image that are not affected by red-eye may be processed by red-eye
reduction. In these cases, select another flash mode and take the picture again.