Filter
Top Products
•
AC
Power
Unit
LA-2
Before using the
AC
unit
, make sure the voltage selector
is set for the proper voltage.
The unit
has
separate settings
for 220 and 240 volts. Insert a small coin in the slot and
turn the screw
so
the slot points to the proper setting (220
or 240). The 100 and
117
volt settings shown in the photo
(1)
cannot be
used
.
To
use
the 100 or
117
volt settings, take
the unit to your nearest Nikon service centre for ad-
justment.
To
connect the
AC
unit, plug one end
of
the power cord
SC-21
into the power socket on the lens barrel
by
aligning
the arrow on the pi
ug
with
the T mark next to the socket
(2)
. Next, align the
white
dot
on the other end
of
the plug
with
the metallic
dot
near the edge
of
the LA-
2'
s power
socket, and push the plug into the socket until it clicks into
place
(3)
. Finally, plug the
AC
cord into a wall outlet. When
the
AC
unit
is switched on, the
pilot
lamp on top
of
the
unit lights up immediately.
To
remove the power cord's plug
from the
AC
unit, grasp the plug by its metal locking ring
and pull
it
out.
Caution
1:
The grounding cord (supplied with the
LA
-
2)
should
be
plugged into the ground terminal
at
the back
of
the
AC
power unit
to ground the
system
whenever possible.
(See
page
21
for details).
Caution 2: Before connecting the power cord
SC
-
21
to
or
discon-
necting
it
from the LA-2, make sure that the power switch
is
off.
Otherwise, the ringlight might
be damaged.
7