Filter
Top Products
7
En
Inserting Batteries
Inserting Batteries
The MB-D14 can be used with one EN-EL15 rechargeable Li-ion battery or with six AA batteries.
Before inserting batteries, be sure that the camera is o and that the MB-D14 control lock is in the L position.
1 Turn the MB-D14 battery-chamber latch to
and remove the battery holder (Figure E).
2 Ready the batteries as described below.
EN-EL15: Matching the indentations on the battery to the projections on the MS-D14EN holder, insert the battery with the arrow
(▲) on the battery toward the battery holder power terminals (Figure F-
q
).
Press the battery lightly downward and slide it in
the direction of the arrow until the power terminals click into place (Figure F-
w
).
AA batteries:
Place six AA batteries in the MS-D14 battery holder as shown in Figure G, making sure that the batteries are in the cor-
rect orientation.
3
Insert the battery holder in the MB-D14 and latch the battery-chamber cover (Figure H). Make sure the holder is fully inserted before
turning the latch.
4 Turn the camera on and check the battery level in the control panel or view nder. If the camera does not turn on, check that
the battery is correctly inserted.
The EP-5B Power Connector
When using the EP-5B power connector, insert it into the MS-D14EN holder with the arrow (▲) on the connector toward the
battery power terminals.
Press the connector lightly downward and slide it in the direction of the arrow until the power termi-
nals click into place (Figure I-
q
).
Open the holder power connector cover and pass the EP-5B power cable through the opening
(Figure I-
w
).