Troubleshootin
FE
E
blinks
FE
E
blinks
•
Lens
is
not
set
to its
• Set lens
to
16
minimum aperture. minimum aperture.
• Batteries are
• Have fresh ones
~appears
nearing
ready.
15
exhaustion.
• Turn the power
off
~blinks
• Batteries are just and replace
15
about
exhausted. batteries with new
ones.
F- -
blinks
F- -
blinks
• Attach CPU lens
• Non-CPU lens is
(except IX-Nikkor)
(F
- -
appears
(F
- -
appears
attached
or
lens is
correctly. (Or set 16
without
blinking
without
blinking
not attached.
the exposure
in
M
mode)
in
M
mode)
mode
to
Manual.)
E,-r
and
Q
blink
• Film is not
Ero-
blinks
correctly
• Reload film.
19
and
E
appears
positioned.
Q
blinks
• Non-OX-coded
• Load OX-coded
19
and
E
appears
film
is
loaded.
film.
•
An
exposed film
• Remove film
Q
blinks
remains
in
the film
cartridge.
27
cartridge chamber.
• Turn the power off
• Battery
power
is
and replace
E ,-,-
and
Q
blink
low
or
temperature batteries with new
35
is
too
low
to
ones. Then, turn
rewind film.
the power on and
rewind film again.
In
certain cases, due
to
static electricity
or
poorly loaded batteries, the
N60/N60QO camera's microcomputer may turn the camera off, even with fresh
properly installed batteries. For the same reason, film may not advance properly.
In
each
of
these cases,
to
resume operation, simply turn the
power
off, then turn
it on again,
or
remove batteries and install them again.
70