Nikon S6200 Camcorder User Manual


 
56
Features That Can Be Set Using the Multi Selector
Shooting Features
Using the Flash (Flash Modes)
You can set the flash mode to match the shooting conditions.
1 Press the multi selector H (m flash mode).
2 Use the multi selector to select the desired
mode and press the k button.
See “Available Flash Modes” (A57) for more
information.
If a setting is not applied by pressing the k button
within a few seconds, the selection will be canceled.
When U (auto) is applied, D is only displayed for
a few seconds, regardless of Monitor settings
settings (A88).
3 Frame the subject and take a picture.
The flash lamp indicates the status of the flash
when you press the shutter-release button
halfway.
- On: The flash will fire when you press the
shutter-release button all the way down.
- Blinking: The flash is charging. The camera cannot take pictures.
- Off: The flash will not fire when a picture is taken.
If the battery is low, the monitor will turn off in order to save power while the flash is
charging.
Auto
76 0
760
29 m 0s
29m 0s
C Effective Range of the Flash
When ISO sensitivity is set to Auto, the flash has a range of 0.5 to 4.6 m (1 ft 8 in. to 15 ft) at the
maximum wide-angle zoom position and a range of 0.5 to 3.0 m (1 ft 8 in. to 9 ft 10 in.) at the
maximum telephoto zoom position.