Filter
Top Products
8
Conserving battery power using the Standby function
• If the SB-30’s power switch is set to the STBY position, the Standby function is activated
only when the Mode selector dial is set to either TTL auto, Non-TTL auto, or Manual
flash mode.
• If the SB-30 and the camera are not used for approx. 40 seconds, the Standby function
activates and automatically turns the SB-30 off to conserve battery power. This is called
the standby state.
• The Standby function does not work if the Mode selector dial is set to the Wireless slave
flash mode. Take care that the power remains on and is consuming.
To turn the SB-30 on again after it enters in the standby state, you can:
• Press the Standby resume button/Slave flash firing cancel button.
• Lightly press the shutter release button on a camera that is compatible with the TTL auto
flash mode.