Filter
Top Products
14
Taking flash pictures in the TTL auto flash mode
4
1
2
1 Set the SB-30’s Mode selector dial to D.
2 Set the camera’s exposure mode, metering system, sync mode, shutter speed, etc.
• The ready-light inside the camera’s viewfinder blinks to warn you that the setting on the camera
is not correct and TTL auto flash is not possible. In this case, make sure the camera settings
are correct.
3 Check the aperture and flash shooting distance range.
• Make sure the main subject is within this range by referring to the table “Determining the aperture and flash
shooting distance range” (p. 15).
• If the camera’s exposure mode is set to Aperture-Priority Auto (A) or Manual (M), set one of the appropriate
apertures obtained from the table on the camera.
4 Make sure the SB-30’s ready-light is on, then shoot.
• Refer to page 13 if the ready-light inside the camera’s viewfinder blinks after shooting.