Filter
Top Products
●
●
●
Settings on the remote flash units
In the Advanced Wireless Lighting mode, set the following items on the remote
flash units.
Communication channel Select one of the four available channels. Be sure to set
the same channel number for both the master flash unit
and remote flash units
Group name A maximum of 3 groups (A, B, C)
• Set the remote flash units’ flash modes and flash output level compensation values on
the master flash unit.
• If wireless repeating flash has been set on the master flash unit, remote flash units such
as the SB-600 will also perform repeating flash operation.
• If a photographer uses the same type of wireless remote flash setup near you, your
remote flash units may accidentally fire in sync with that photographer’s master flash
unit. To avoid this, use a different channel number.
•Refer to your Speedlight user’s manual for information on master flash unit settings.
●
●
●
Setting a group and channel number on the remote flash units
1
Press the
a
button on the remote flash unit to
display the blinking channel number, then press
the
i
or
j
button to set the channel number.
• Be sure to choose the same channel number as set
on the master flash unit.
2
Press the
a
button on the remote flash unit to
display the blinking group, press the
i
or
j
button
to set the group, then press the
a
button.
• For remote flash units where the flash mode and flash
output level compensation values are to be set
identically, place these flash units into the same group.
v Notes on using camera’s built-in flash in Commander mode
Camera Available flash mode of Usable channel Usable group
built-in flash number
D700, D300
-Series
,
TTL, M, -- (Flash canceled) 1 to 4 A, B
D200, D90, D80
D70-Series (Flash canceled) 3 A
63
Advanced operations